This is the ElectriFly 11.1V 3S LiPo Balance Charger
with DC Car Adapter and AC/DC Adapter from Great Planes.
**Will not work on the Heli-Max AXECPv3.**
FEATURES: Charge batteries with 800mAh capacity or greater
Designed for 3-cell lithium-polymer batteries only
Uses the "constant current/constant voltage" charge method
Automatically starts charge upon connection of the battery to the
balance plug
Bi-color LED indicates charging status (red when battery is charging
and green when battery is completely charged
One year limited warranty, USA and Canada only
INCLUDES: One 11.1V 3S LiPo balance charger with DC car adapter and AC/DC
adapter
SPECS: Charger-
Input voltage: 11.7V-15V DC
Battery types, # cells: 3 lithium-polymer cells connected in
series (11.1V LiPo)
Charge current: 800mA maximum
Charge method: CC-CV (current drop-off termination)
Minimum battery capacity: 800mAh
Status indicator: One bi-color LED
Input connectors: polarized DC power jack for DC input
Output connectors: one 3S balance plug
Case size: 2 x 1.1 x 2.7" (50 x 30 x 70mm)
Weight: 2.7oz (76.54g)
AC/DC Adapter-
Input: 100-240V AC
Output: 12V DC 1A
Lead Length: 59" (150cm)
DC Adapter-
Lead Length: 115" (292cm)
IMPORTANT CAUTION: DO NOT over-discharge your battery. Using a Lithium-Polymer
Polymer (LiPo) battery down to a low voltage can damage the
battery. If your model does not include a voltage cut-off
device, you must stop flying when power begins to decline. Do not
continue using the battery once the battery charge starts to drop.
COMMENTS: Special note to users of HeliMax Axe CP-L - purchased before May
2008:
DO NOT use this charger for the GPMP0401 ElectriFly 950 mAh 11.1V
battery. In addition, if your Axe CP-L helicopter does not have a
LiPo Protection Module (LPM) installed, you must be cautious and
avoid discharging the battery too far. Be sure to safely land your
helicopter and recharge when the power starts to decline. If you
continue to use the battery power after this point it could
damage the battery and result in a fire. If you are not sure if
your Axe CP-L has a LiPo Protection Module or if you have
questions regarding the recall of the GPMP0401 battery you may
contact HeliMax at 1-866-462-2426 or helihotline@hobbico.com for
more details.
Charge only lithium-polymer rechargeable batteries that are 3S
(3 cells in series) 11.1V nominal voltage, greater than 800mAh,
which have a balance connector
Do not attempt to use this charger with NiCd, NiMH or different
types of Lithium-Ion batteries as they are not compatible
Do not leave the charger unattended while charging. Disconnect the
battery and remove input power from the charger immediately if
either becomes hot. However, it is normal for the charger to
get warm
Disconnect the battery from the charger immediately and remove
the battery to a fireproof location if the battery begins to swell
or smoke!
Only use the included car adapter or approved AC adapter to power
the charger
Do not allow water, moisture or foreign objects into the charger
Do not block the air intake holes, which could cause the charger
to overheat
Do not place the charger or any battery on a flammable surface or
near a combustible material while in use
Do not charge on a carpet, cluttered workbench, paper, plastic,
vinyl, leather, wood or inside an R/C model
Never charge inside a full-sized vehicle
Always disconnect charger from input power when not in use
Do not attempt to charge a battery if is is swollen or hot
Keep out of the reach of children
