Tarjeta MercadoPago, la primer tarjeta recargable para compras online.Solicita tu tarjeta
Tarjetas de débito
Depósito y transferencia bancaria
Con MercadoPago tienes 100% de cobertura frente a problemas gracias al Programa de Protección al Comprador.
Elige la opción Lo acuerdo con el vendedor.
Al terminar tu compra, recibirás los datos de tu contraparte para coordinar el pago.
Contáctate con el vendedor para definir el medio de pago del producto.
This board is a simple carrier for Allegro?s 30A ACS715 Hall effect-based linear current sensor. This version accepts a unidirectional current input up to 30 A. The output is an analog voltage (133 mV/A) that reads 500 mV for no input current and has a typical error of less than 1.5%.
This current sensor is a carrier board or breakout board for Allegro?s ACS715LLCTR-30A-T Hall effect-based linear current sensor; we therefore recommend careful reading of the ACS715 datasheet before using this product. The sensor operates at 5 V and has an output sensitivity of 133 mV/A. The following list details some of the sensor?s key features:
The pads are labeled on the bottom silkscreen, as shown in the picture to the right. The silkscreen also shows the direction that is interpreted as positive current flow via the +i arrow.
The sensor requires a supply voltage of 4.5 ? 5.5 V to be connected across the Vcc and GND pads, which are labeled on the bottom silkscreen. The sensor outputs an analog voltage that is linearly proportional to the input current. This output voltage is offset by 500 mV and increases by 133 mV per amp of input current. The output voltage decreases linearly below 500 mV for currents as low as -1.5 A.
The input current can be connected to the board in a variety of ways. For low-current applications, you can solder 0.1" male header pins to the board via the small through-holes on the input-current side of the board. For higher-current applications, you can solder wires directly to the through-holes whose sizes best match your wires, or you can use solderless ring terminal connectors, as shown in the picture to the right. The large through-holes are big enough for #6 screws.
The board has two mounting holes on the logic side of the board. These mounting holes are 0.5" apart and are designed for #2 screws.
The IC has an internal filter resistance of 1.7 k?, and the carrier board includes a 1 nF filter capacitor, which produces a low-pass RC filter with a 90 kHz cutoff. You can improve sensing system accuracy for low-frequency sensing applictations by adding a capacitor in parallel with the integrated 1 nF capacitor across the pads marked ?filter? on the bottom silkscreen (this capacitor is labeled C2b in the schematic below). The frequency F that the filter will attenuate to half its original power is given by:
F = 1 / (2?RC) = 1 / (11k? * (1 nF + Cf))
where Cf is the value of the capacitor added to the filter pads.
|Size:||0.7" x 0.8"|
|Current sense:||0.133 V/A|
|Minimum logic voltage:||4.5 V|
|Maximum logic voltage:||5.5 V|
|Supply current:||13 mA|