SPECIFICATIONS(especificaciones)

                                                            D2100.1

STABLE TO:                                      1 ohm

SINE-WAVE POWER

@ 13.8 Volts:

Watts @ .05 ohms mono                         N/A

Watts @ 1 ohms mono                            N/A

Watts @ 2 ohms mono                      1 X 2100

RESISTIVE (RMS) POWER

@ 13.8 Volts:

Watts @ .05 ohms mono                      N/A

Watts @ 1 ohms mono                         N/A

Watts @ 2 ohms mono                        1 X 1550

Idle Current:                                 1.5 amp           

Signal to Noise Ratio A-Wtd:             <85dB

Total Harmonic Distortion:                  0.3%

Channel Separation:                             N/A      

Input Sensitivity:                             150mV-2.5V      

Slew Rate:                                       13V / Usec      

Fuse Rating:                                      80 amp            

Dimensions:

Height:                                    2.25”

            Width:                                    11.375”

            Length:                                  11.375”

General Information:

Frequency Response:               <10Hz to 275Hz

Low-pass Filter:                       Variable 24db, 77 to 275Hz

Battery Connectors:                  2 Gauge

Speaker Connectors:                8 Gauge

CONTROLS AND CONNECTORS

(1) Positive Power Terminals –This is the power feed from the positive (+) terminal of the car’s battery. Use 4-gauge cable (MINIMUM) and good quality terminals when routing this connection. Tighten all connections well to prevent power loss due to bad contact. Route the power cable away from the RCA jacks and speaker cables

(1) Ground Terminals - For optimum performance, use 4-gauge cable MINIMUM! Connect this cable to your battery’s negative (-) terminal or to a secure area of the body in the trunk. *See note below.

Remote Terminal - The amplifier will turn on when 12 volts is applied to this terminal. This 12-volt signal is usually taken from the Power Antenna or Remote wire coming from the source unit.

Speaker Terminals - Connect to speakers using 16-gauge wire (minimum). Running too low of a speaker impedance will cause the amplifier to go into a fault condition.

Crossover Filter – Linkwitz/Riley 24db slope. This control sets the 6db down point of your amplifier.

Gain – Allows input levels between 150mV (max gain) and 2.5 volts (min gain) for full output.

Recommended Fuse – 80 amperes.