Bocina Cerwin Vega Dsm 200

Descripción

): These models are equipped with both a pin Speakon connector and two _” phono jack inputs. The default position of the 4 pin Speakon
connector is 1+ and 1-. However, there is an internal connector that enables the use of the 2+ and 2- pins (and disconnects the 1+, 1- connection). This connector is only accessible by removing the 6
screws of the input plate (on the rear of the loudspeaker) and changing the position of the 2 pin connector on the rear of the input plate. This connector allows of optimum hook-up flexibility.
SUBWOOFER (PSX-36): This model also uses both a 4 pin Speakon connector and _” phono jack inputs, but also incorporates a 150Hz high-pass output. (This internal high-pass crossover substantially
improves the effective power handling of the pole-mounted full-range cabinet while minimizing amplifier load.) The high-pass crossover is activated by using the 1+ and 1- input and output on the 4 pin
Speakon connectors, or by using the _” phono jack input and output. The low-pass and high-pass crossover's are individually bypassed when using the 2+ and 2- input and output on the 4 pin Speakon
connector. This allows for the flexibility of biamp operation with an electronic crossover (not included).
FLOOR MONITOR/SATELLITE (PSX-122): This model is equipped with both a 4pin speakon connector and two phone jack inputs. The default position of the 4pin Speakon connector is 1+ and 1-. The default
position is optimized for use when the speaker is on the ground - as a floor monitor. It is suggested that when using the PSX-122 on a pole, mounted above the PSX-36, the 2+ and 2- pin connection be
used. To switch from the 1+ and 1- pins to the 2+ and 2- pins, the position of the internal connector must be switched. This connector is only accessible by removing the 6 screws of the input plate (on the
side of the loudspeake